How to remove the original Intel fan
During the DIY computer assembly or upgrade process, disassembling the CPU fan is a common operation. Intel's original fans require certain skills to disassemble because of their unique buckle design. This article will detail how to safely disassemble an original Intel fan, along with relevant tools and precautions.
1. Preparation work
Before disassembling the original Intel fan, you need to prepare the following tools and materials:
| Tools/Materials | Purpose |
|---|---|
| Phillips screwdriver | Used to loosen fan fixing screws |
| Plastic pry bar | Auxiliary separation of fan and CPU |
| Alcohol pads | Clean silicone grease residue on CPU surface |
| New silicone grease (optional) | Use when reinstalling |
2. Disassembly steps
Here are the detailed steps to remove an original Intel fan:
| steps | Operating Instructions |
|---|---|
| 1. Power outage | Turn off the computer and unplug the power cord for safety. |
| 2. Remove the radiator power cord | Gently unplug the 4-pin fan power cable connected to the motherboard. |
| 3. Loosen the buckle | Use a screwdriver to turn the screws at the four corners of the fan counterclockwise until the buckle is completely loosened. |
| 4. Shake gently | Hold both sides of the fan with both hands and shake it gently from side to side to avoid damaging the CPU with excessive force. |
| 5. Remove the fan | After the buckle is completely loosened, lift the fan vertically upward. |
3. Precautions
Please pay attention to the following when disassembling the original Intel fan:
1.Avoid using too much force: The buckle design of the original Intel fan is tight, but excessive force may cause damage to the motherboard or CPU.
2.Check silicone grease status: If the silicone grease has dried up, it is recommended to run it for a period of time to let the CPU heat up and soften the silicone grease before disassembling it.
3.Clean CPU surface: After disassembly, be sure to use alcohol cotton pads to clean the remaining silicone grease on the CPU surface to ensure good heat dissipation when reinstalling.
4.avoid static electricity: Touch metal objects to release static electricity before operation to prevent static electricity from damaging electronic components.
4. Frequently Asked Questions
| question | solution |
|---|---|
| The fan buckle cannot be loosened | Check that the screw is fully turned counterclockwise, and if necessary, shake the fan slightly to assist in loosening it. |
| The CPU is pulled out together with the fan | It may be caused by silicone grease adhesion. Gently rotate the fan left and right to separate it. |
| Screw slide | Use rubber pads or pliers to assist in turning the screws to avoid further damage. |
5. Reinstallation suggestions
If the fan needs to be reinstalled, it is recommended to follow these steps:
1.clean surface: Make sure the CPU and fan base are free of dust and old silicone grease residue.
2.Apply new silicone grease: Apply an appropriate amount of silicone grease to the center of the CPU surface. It is recommended to use a "pea-sized" amount.
3.Align the fasteners: Align the four-corner screws of the fan with the motherboard holes to ensure the correct installation direction.
4.Uniform force: Tighten the screws diagonally to avoid uneven stress on one side.
With the above steps, you can safely remove and reinstall your original Intel fan. If you encounter difficulties during operation, it is recommended to consult a professional or refer to Intel's official guide.
check the details
check the details
en
